Preferences tab
On this tab you can configure the following settings for the AutoCapture server.
| Option | Description |
|---|---|
| Home Directory | The root directory is the working folder where the server creates all temporary directories and files necessary for controlling device related traffic. The account used to run the server must have permission to write to this folder. |
| Port Number | The port that the AutoCapture server uses to communicate with clients. The port setting for AutoCapture clients must match this port number. The default port is 8085. |
| Secure communication (SSL) | Enable this option to allow information exchange between the
server and the clients to be over an SSL (Secure Sockets Layer) secured
connection. This option requires an SSL enabled client.
If the AutoCapture client was installed prior
to this feature enhancement, the client will not support SSL encryption. The
user will need to upgrade to the latest SSL enabled client.
|
| Processed Files | Select this check box to save processed files. This is the
folder where the captured files are stored after they are successfully routed.
If you select this check box, all files are stored into the
Processed Files folder when the service
successfully completes writing them into the destination location.
Enabling this option saves a copy of every
successfully routed file in this folder. Make sure that sufficient disk storage
is allocated for this folder.
|
| Rejected Files | Select this check box to save rejected files. This folder is used for storing any files that were not routed successfully. Typically, a secondary process uses this folder as an input folder to notify a system administrator of the failure. A system administrator can then identify reasons for failures by searching application log file entries. |
| Directory Service type |
This setting defines the user security restrictions mode. It is set at configuration time and applied at run time. At configuration time, the appropriate user and group picker is displayed based on this setting for defining members in Group settings. At run time, the group membership of the user using AutoCapture client is validated against the defined identification source. In case of Microsoft Entra ID, the connection parameters
set in Configuration Assistant are used to connect to the directory service.
|